Conceiving Board Manufacturing Co,. Ltd.
Business type: Manufacturer,Exporter,Seller
Telephone : 86-757-86688986
Add：Shishan Industrial Zone A Park, Nanhai, Foshan, Guangdong, China
|Place of Origin:||Foshan, China|
|Certification:||ISO, BV, AISC, CE, ASTM, ATSN, SGS|
|Minimum Order Quantity:||360 sq.m|
|Packaging Details:||Carton package for pallet packing|
|Delivery Time:||Within 30 days upon receiving deposit and order qty.|
|Payment Terms:||T/T,30% advance, 70% before shipment.|
|Supply Ability:||36000 sq.m|
Home Decoration kitchen Wall Glass Mosaic Tiles Linear
Chip Size:mixed size
Sheet size: 296x300x8mm
Joint :2 mm
Finish: glossy or matte
Installation of glass mosaic:
Before you Begin:
Glass Mosaics may be installed on interior or exterior wall areas, in wet or dry locations (even in hot or cold environments). Glass differs from ceramic products, so extra caution and attention to installation instructions is recommended. In every case glass tiles should not be exposed to high abrasion, high impact and thermal shock or installed over flexible surfaces.
Important –Since any crack in a glass tile is very visible, the use of a crack suppression membrane is recommended when installed over a mortar bed (except when used as an accent). Many substrates may continue to cure and shrink over a period of months, and a crack suppression membrane prevents shrinkage or movement of the substrate to mirror through the tile.
Install only over well-cured, stable substrates. Allow for an expansion joint whenever substrates change.
Use a white thin-set mortar (2-component, flexible acrylic thin-set mortar system) formulated for interior and exterior wall installations. Using the flat side of a trowel to initiate the bond coat, firmly apply the setting material to the substrate.
With additional setting material, using a 3/16” x ¼” V-Notch trowel, comb horizontal, full notches in one direction to establish the proper depth of the setting bed.
Using the flat side of the trowel, flatten the notches to achieve a smooth, consistent setting bed approximately 1/8” thick.
Apply sheets into the setting bed (paper side towards you), using light even pressure to establish contact and eliminate any voids.
To achieve a uniform surface, tap lightly using a wooden beating block and a hammer.
Caution: Do not use rubber floats or steel trowels for this step.
Apply each subsequent sheet so that grout joints line up and a consistent field is maintained.
Prior to setting each sheet, check the setting bed for skinning (slight drying of the thin set surface). If skinning occurs, remove thin-set and repeat steps 2 & 3.
To unify the tile surface from one sheet to the next, use a wooden beating block and hammer, again
lightly tapping from one sheet to the next.
After 15 – 30 minutes (floors can be removed sooner) lightly wet paper several times over a 5 – 10 minute period.
Tip: To increase water absorption try using warm water.
After water has absorbed into paper,the glue will release from the mosaics.Peel paper starting at the corner of the sheets. Removing paper while the setting material is still in a semifresh/
flexible state allows for necessary adjustments and reassures dye lot color consistency.